The Hi-Ride sheath adapter is a simple, yet comfortable mounting solution for your kydex sheath. Available with 1.5" or 1.75" belt clip sizes, this adapter can be carried IWB (Inside the Waistband), or OWB (Outside the Waistband). The Belt Clip is mounted with countersunk screws on the back side so it will ride as close to the sheath as possible. The Hi-Ride adapter is intended to be mounted on the upper most eyelets of a kydex sheath. The adapter's mounting holes are slotted to fit range of eyelet widths. Please use the measurement specs below to see what will fit your sheath. If you do not have eyelets in the location you would like this clip, than you can drill your own holes in the kydex sheath to mount it to the height that you want.
- .125" Thick Kydex
- Black Oxide Fasteners
Mounting hole widths on adapters
(center to center on 7/32" diameter chicago screws)
Small: 1.8" - 2.15"
Medium: 2.15" - 2.45"
These measurements are the minimum to maximum mounting hole width.
These adapters will fit the following factory sheaths:
**NOTE: IF IT'S NOT LISTED, THEN WE DO NOT KNOW WHAT SIZE YOU WILL NEED FOR YOUR SHEATH.**
Please use the measurements listed above to verify what size you will need.
SURVIVE! GSO4.1 Gen 1 & Gen 2
SURVIVE! GSO3.5 Gen 1
Carothers Field Knife
Carothers Utility Field Knife (FK2)
SURVIVE! GSO5 Gen. 1
SURVIVE! GSO5.1 Gen 1 & Gen. 2
SURVIVE! GSO6 Gen. 1
SURVIVE! GSO7/7 Gen. 1
ESEE Laser Strike