This adapter bolts to the back of your sheath, and allows you to carry your sheath with multiple belt attachment options. All the necessary mounting screws and spacers are included.
- Made from 9oz Wickett & Craig Leather
- .125" Thick Molded Kydex
- Black Oxide Fasteners
**You need to measure your sheath to pick the correct adapter.**
Mounting hole widths on adapters
(center to center on 7/32" diameter chicago screws)
Small: 1.8" - 2.15"
Medium: 2.15" - 2.45"
These measurements are the minimum to maximum mounting hole width.
These adapters will fit the following factory sheaths:
**NOTE: IF IT'S NOT LISTED, THEN WE DO NOT KNOW WHAT SIZE YOU WILL NEED FOR YOUR SHEATH.**
Please use the measurements listed above to verify what size you will need.
SURVIVE! GSO4.1 Gen 1 & Gen 2
SURVIVE! GSO3.5 Gen 1
Carother Field Knife
Carothers Utility Field Knife (FK2)
SURVIVE! GSO5 Gen. 1
SURVIVE! GSO5.1 Gen 1 & Gen. 2
SURVIVE! GSO6 Gen. 1
SURVIVE! GSO7/7 Gen. 1
ESEE Laser Strike
This is a blank adapter without mounting holes. IT IS WIDER THAN THE MEDIUM ADAPTER.
Only use this adapter if your sheath has a wider mounting hole width than the Small or Medium adapters.
Line up your eyelet mounting holes, mark your holes and drill them out.
This adapter is 3.25" wide at the lower mounting area (where it bolts to your sheath). You may have to trim off excess kydex if your sheath is narrower than this.
Maximum recommended mounting hole width (center to center of eyelets) is 2.875".